Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Before
After
Before
After
Before
AfterFast, Reliable Door Installation Across Haltom City
Door installation in Haltom City, TX typically runs $1,200 to $3,800 for a standard entry door replacement, and $2,500 to $6,500 when the opening needs reframing or custom flashing work. Most of the ranch homes here were built between 1945 and 1970 with rough openings sized for hollow steel doors that no longer exist. That’s the real reason a Haltom City door job is never just a swap. We measure every opening before we quote, because the quote and the measurement are the same document under Haven Clause 1. If you’re off Belknap Street or south of Airport Freeway and the door sticks, drafts, or leaks, call (509) 265-6387 and we’ll put a written price in your hands before any tool is lifted.
Why Sightline Windows & Doors Is Haltom City’s Preferred Door Installation Company
We’ve pulled enough 1960s hollow steel doors off brick-veneer ranches in Haltom City to know what’s behind them before we even set the saw down. Most of the time it’s a rough opening that’s half an inch out of square, a threshold that’s rotted into the slab, and brick veneer that has to be cut back to make a modern pre-hung unit fit. Our Door Installation crews have been documenting jobs like this since 2012, over 18,000 openings across eight product categories, every one with a written price before work started and a photo record when it finished. The photo record is part of the Haven Standard, clause four: Evidence on every job. When we’re done on a Haltom City home, you get a documented file of what was found, what was done, and what the opening looks like after. Sonia Raman, who leads Sightline, writes the same promise into every scope: if it’s not done right, we make it right, for 365 days after the install. No fine print, no callback runaround.
Our Door Installation Services in Haltom City
Replacement Doors
Replacement doors are the backbone of our work in Haltom City. The 900 to 1,400-square-foot brick-veneer ranches here frequently still carry the original hollow steel entry doors installed when the subdivisions went in. Those doors are narrow, thermally worthless, and usually rusted at the bottom where sprinkler overspray hits them for forty years. We spec replacement units by the actual rough opening measurement, not by what the supply house has in stock. When the opening is non-standard, which it often is on the streets south of Airport Freeway, we reframe and rebuild the jamb rather than hang a door that will never seal.
Entry Doors
An entry door on a Haltom City ranch does more than open and close. It’s the first thing a hailstorm hits, the main thermal boundary at the front of the slab-on-grade house, and the security point most often kicked in during a break-in. We install entry doors from Therma-Tru, PGT, and CWS, specified by U-factor and design pressure rather than by margin. A fiberglass Therma-Tru unit with an insulated core and a composite frame will outperform the original steel door by a wide margin, and it won’t dent like the hollow steel did. We measure sightlines and square before quoting, because a door that fits the opening is a door that seals.
Storm & Exterior Doors
Storm doors in Haltom City have to survive two things: golf-ball hail from April to June and 105-degree afternoons in July. A flimsy aluminum storm door won’t do either. We install storm and exterior doors with laminated or impact-rated glass where the opening calls for it, and we flash the threshold so water from a North Texas downpour can’t pond against the slab and rot the subfloor. If you’ve got a back door facing the alley and it’s taken hail damage on the glass lite, the next storm doesn’t get easier. Call (509) 265-6387 and we’ll scope the replacement before it fails.
French & Double Doors
French and double doors show up in Haltom City on 1970s additions and on ranch homes where a patio was enclosed later. The problem is the same one we see across the city’s older stock: the rough opening was never framed square, the header sags, and the two leaves drift until they bind at the top or gap at the bottom. We rebuild the rough opening, set a continuous sill pan, and install a double door that actually meets in the middle. We’ve done this enough times on streets off Denton Highway to know the fix before we quote it.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Haltom City
We install and service doors from Therma-Tru, PGT, CGI, and CWS, and we keep the most common Haltom City replacement parts in our Dallas-Fort Worth warehouse so a jamb repair or threshold rebuild doesn’t wait on a factory lead time. PGT and CGI make the impact-rated units we recommend for the hail corridor that Haltom City sits squarely inside. Therma-Tru fiberglass entry doors are our go-to for the narrow ranch openings where a molded skin and composite frame hold up better than a steel slab. We specify by what the opening requires, not by what’s been sitting in inventory since last season.
Common Door Installation Problems We See in Haltom City Homes
- Entry door rough openings framed for 30-inch hollow steel doors. Hundreds of 1950s and 1960s Haltom City ranches have rough openings that are too narrow for today’s standard 32-inch pre-hung units. A stock door from a big-box store won’t fit without reframing, and the foam-and-caulk shortcut fails in two years when the Texas heat cycles the frame apart.
- No sill pan on slab-on-grade ranches. Builders in the 1950s and 1960s set steel doors right on the slab with a bead of caulk. Sixty years of North Texas downpours later, the caulk is gone and the oak threshold has rotted into the concrete. We rebuild these with pressure-treated lumber and a custom aluminum sill pan that drains water away from the opening.
- Standard glass lites in a hail corridor. Tarrant County ranks among the highest hail-claim counties in Texas every year. A standard exterior door with a non-impact glass lite will shatter during the next golf-ball hail event and leave the house open. We specify laminated or impact-rated glass for any door with a lite.
- Out-of-square rough openings on rental stock. A significant portion of Haltom City homes are rentals with years of deferred maintenance. Frames shift, headers sag, and the door binds at the top corner. We measure every opening for square, level, and plumb before quoting, so the written price accounts for the reframing before we start.
Pricing for Door Installation in Haltom City, TX
A straightforward entry door replacement in Haltom City on a standard 32-inch opening typically runs $1,200 to $2,400 for the unit and install. The same job on a 1950s ranch with a 30-inch rough opening that needs reframing, brick veneer cutting, and a rebuilt jamb runs $2,500 to $6,500. Storm and exterior doors range from $800 to $2,200 depending on glazing and frame material. French and double door installs run $3,000 to $7,500 when the header and rough opening need work. Every quote includes the measured survey you keep, a written scope, and the Haven Standard photo record. We don’t do estimate ranges that balloon after the first day. Call (509) 265-6387 and we’ll put the exact number in writing.
Bring us a competitor’s written estimate and we’ll review it at no charge. If ours is higher, we’ll show you why in the scope, line by line. The goal isn’t to win a price war; it’s to give you a number that means something on the first day and the last.
We Also Serve Cities Near Haltom City
Our Haltom City crews also cover Fort Worth, North Richland Hills, Hurst, and Bedford. The same non-standard openings and slab-on-grade conditions show up all around the northeast Tarrant County corridor, so the pricing and scoping work the same way. Call (509) 265-6387 and we’ll schedule a measured survey wherever you are in the area.
Serving Haltom City, TX - Our Local Coverage Area
We’re based in the Haltom City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Door Installation in Haltom City
Because the big-box store sells you a standard 32-inch pre-hung door, and your 1960s ranch was framed for a 30-inch hollow steel door that’s been out of production for fifty years. Making the standard door fit means cutting the brick veneer back, reframing the rough opening, rebuilding the jamb with pressure-treated lumber, and installing a custom sill pan so water can’t rot the threshold again. That’s a full day of additional labor and materials, and it’s why the written price on your Haltom City home runs $2,500 to $6,500 instead of $1,500. Call (509) 265-6387 and we’ll show you the measurement and the scope before you sign anything.
Yes. An impact-rated door from PGT or CGI will protect the opening even if the windows around it are still single-pane. The door is the security point and the hail point; a laminated glass lite won’t shatter when a golf-ball hailstone hits it. The windows can be upgraded later as budget allows, but the door doesn’t depend on them. Call (509) 265-6387 for a written estimate on the door alone. Estimates are free.
Yes, and in Haltom City the difference is measurable. The February 2021 freeze blew seals on thousands of original hollow steel doors and cracked weatherstripping all across the city’s ranch stock. A new fiberglass entry door with an insulated core, compression weatherstripping, and a properly flashed sill will stop the drafts at the threshold and the jamb. The U-factor on a modern Therma-Tru unit is roughly half that of a 1968 steel slab with no thermal break. Call (509) 265-6387 and we’ll scope the replacement and give you a written price.
For a like-for-like door swap on an existing opening, Haltom City typically does not require a permit. When we reframe a rough opening or cut brick veneer, the work falls under a structural alteration, and we pull the permit and pass the inspection as part of the written scope. We don’t leave you guessing about code; the permit is either in the written price or we tell you why it isn’t needed. Call (509) 265-6387 for an exact answer on your specific opening.
Yes, and this is one of the most common replacement jobs we do in Haltom City on homes off Belknap Street and south of Airport Freeway. The original quarter-round jalousie doors were framed to non-standard widths that don’t match modern pre-hung units. We cut the opening to a standard size, reframe the rough opening, install a pre-hung insulated door with a proper sill pan, and flash the exterior so it drains. The old aluminum door goes to scrap, and the back of the house stops leaking air. Call (509) 265-6387 and we’ll schedule the measured survey.
Written by Sonia Raman, Owner at Sightline Windows & Doors, serving Haltom City under the Haven Standard since 2012.